The impact of data assimilation into the meteorological WRF model on birch pollen modelling.

We analyse the impact of ground-based data assimilation to the Weather Research and Forecasting (WRF) meteorological model on parameters relevant for birch pollen emission calculations. Then, we use two different emission databases (BASE - no data assimilation, OBSNUD - data assimilation for the meteorological model) in the chemical transport model and evaluate birch pollen concentrations. Finally, we apply a scaling factor for the emissions (BASE and OBSNUD), based on the ratio between simulated and observed seasonal pollen integral (SPIn) to analyse its impact on birch concentrations over Central Europe. Assimilation of observational data significantly reduces model overestimation of air temperature, which is the main parameter responsible for the start of pollen emission and amount of released pollen. The results also show that a relatively small bias in air temperature from the model can lead to significant differences in heating degree days (HDD) value. This may cause the HDD threshold to be attained several days earlier/later than indicated from observational data which has further impact on the start of pollen emission. Even though the bias for air temperature was reduced for OBSNUD, the model indicates a start for the birch pollen season that is too early compared to observations. The start date of the season was improved at two of the 11 stations in Poland. Data assimilation does not have a significant impact on the season's end or SPIn value. The application of the SPIn factor for the emissions results in a much closer birch pollen concentration level to observations even though the factor does not improve the start or end of the pollen season. The post-processing of modelled meteorological fields, such as the application of bias correction, can be considered as a way to further improve the pollen emission modelling.

Extension of WRF-Chem for birch pollen modelling-a case study for Poland.

In recent years, allergies due to airborne pollen allergens have shown an increasing trend, along with the severity of allergic symptoms in most industrialized countries, while synergism with other common atmospheric pollutants has also been identified as affecting the overall quality of citizenly life. In this study, we propose the state-of-the-art WRF-Chem model, which is a complex Eulerian meteorological model integrated on-line with atmospheric chemistry. We used a combination of the WRF-Chem extended towards birch pollen, and the emission module based on heating degree days, which has not been tested before. The simulations were run for the moderate season in terms of birch pollen concentrations (year 2015) and high season (year 2016) over Central Europe, which were validated against 11 observational stations located in Poland. The results show that there is a big difference in the model's performance for the two modelled years. In general, the model overestimates birch pollen concentrations for the moderate season and highly underestimates birch pollen concentrations for the year 2016. The model was able to predict birch pollen concentrations for first allergy symptoms (above 20 pollen m-3) as well as for severe symptoms (above 90 pollen m-3) with probability of detection at 0.78 and 0.68 and success ratio at 0.75 and 0.57, respectively for the year 2015. However, the model failed to reproduce these parameters for the year 2016. The results indicate the potential role of correcting the total seasonal pollen emission in improving the model's performance, especially for specific years in terms of pollen productivity. The application of chemical transport models such as WRF-Chem for pollen modelling provides a great opportunity for simultaneous simulations of chemical air pollution and allergic pollen with one goal, which is a step forward for studying and understanding the co-exposure of these particles in the air.